Today's core mold vibration process has long been recognized and accepted by major small and medium-sized enterprises, and through continuous research and development and innovation in recent years, it has become a mature pipe-making process. There is no doubt about the quality of the products produced, and in terms of its own characteristics and advantages, compared with traditional craftsmanship, it has many advantages. Our previous cement pipe-making process requires a lot of manual labor. Nowadays, the mandrel vibration process adopts mechanized operation production, which not only saves labor, but also greatly reduces the labor labor, even for older people. A little operator can also be competent for this job, and jobs are also provided for the employment of the elderly. The whole process of this process is less, which removes many trivial affairs in traditional processes, saves time and improves efficiency. This process equipment uses dry and hard concrete, so the cement pipe produced has high quality strength and good uniformity, which is also impossible to achieve by traditional processes.

I have learned so much about the vibration of the core mold and the radial extrusion process before, and everyone must have some understanding. So how do these pipe-making processes make cement pipes? This question must be what everyone wants to know. Today, I will talk about how cement pipes are made. Since it is the production of cement pipes, sand, stones, cement, etc. must be used as raw materials for production. After that, it was applied to our pipe-making equipment and principles, using the roller pressure and centrifugal force generated by the rotation of the roller shaft and the steel mold to make the raw material densely formed. It can be said that the hanging roller pipe making machine is a very simple and practical cement pipe making equipment. Its application range includes the production of drainage, sewage, highway culverts and machine shaft pipes, and adopts a new structure with two fulcrums. Its production process is firstly that the pipe mold is driven by the roller, rotates at different speeds at different stages according to the requirements, continuously feeds a certain amount of concrete, and is compacted under the action of the pressing shaft and centrifugal force to complete the production of cement pipes. .

Radial extrusion can be said to be a combination of a variety of pipe-making equipment, and has certain requirements for the size of the operating workshop environment. First of all, a workshop of about 1,800 square meters is required, and the height must not be less than 13 meters. The following will introduce the components of the radial extrusion equipment. Concrete placing machine: This equipment is located above the pipe making machine, which can effectively convey the concrete evenly to the pipe form, and control the speed of the material according to the actual demand. Multi-layer extrusion head: using a counter-rotating vibrator, the vibrator includes a high-speed running device and a low-speed tamping device. The rotation directions of the two are diametrically opposite, and the compaction device is mainly driven by two infinitely adjustable hydraulic motors. It can effectively densify the concrete and control the deformation of the reinforcement cage. Socket vibrator: The socket of the concrete pipe is formed by the vibrator installed under the main machine through the vibration operation. Electronic control system: This system can effectively control the speed at which the concrete is filled into the mold, and it can also control the rising speed of the vibrator.